Module No. 5682

Setting a Start Time

The start time can be set in 1-minute units up to 60 minutes.

  1. Enter the Timer Mode.

    2. Navigating Between Modes

  2. Pull out the crown.

    3. This causes the minutes digits to flash.

    5660_72_TMR

  3. Rotate the crown to change the timer start time minutes.

  4. Push the crown back in to complete the setting operation.

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

Back

Next