Module No. 5673

Setting the Auto Measurement Interval

You can select an auto measurement interval of either five seconds or two minutes.

  1. Enter the Altimeter Mode.

    2. Navigating Between Modes

  2. Pull out the crown.

    3. This displays the altitude for your current location.

    5673_ALTI_Ofset_Mode

  3. Press (B).

    4. This causes the auto measurement interval to appear on the display.

    5673_54_ALTI

  4. Rotate the crown to select [0’05] or [2’00] as the auto measurement interval.

    5. [0’05]: Readings taken every second for the first three minutes, and then every five seconds for about the next one hour.

    [2’00]: Readings taken every second for the first three minutes, and then every two minutes for about the next 12 hours.

  5. Push the crown back in to complete the setting operation.

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

The watch will automatically return to the Timekeeping Mode if you do not perform any operation in the Altimeter Mode for about one hour while [0’05] is selected as the measurement interval or about 12 hours while [2’00] is selected.

Back

Next