Module No. 5673

Adjusting Hand Alignment

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Pull out the crown.

    3. This causes [CITY] to flash on the display and the second hand to move to the current Home City.

    5673_HT_SET_common

  3. Hold down (A) for at least five seconds. Release the button when [HAND ADJ] starts to flash.

    4. This indicates that hand alignment adjustment has started.

    [HAND SET] will flash first on the display about 0.5 seconds after you hold down the (A) button. Keep the button depressed until [HAND ADJ] flashes on the display.

    5673_73_fl_HAA

  4. After all the hands move to 12 o’clock, push the crown back in.

    5. This returns the hands to normal timekeeping.

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

Important!

After hand position adjustment is complete, check to make sure that the proper time is being indicated in the Timekeeping Mode by the hands and on the display. If the hands are misaligned, perform steps 2 through 4 again.

Back

Next