Module No. 5673

Enabling the Button Operation Tone

Use the procedure below to enable or disable the tone that sounds when you press a button.

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Pull out the crown.

    3. This causes [CITY] to flash on the display and the second hand to move to the current Home City.

    5673_HT_SET_common

  3. Press (B) twice.

    4. This causes [KEY♪] or [MUTE] to flash on the display.

    5673_75_other

  4. Rotate the crown to select either [KEY♪] or [MUTE].

    5. [KEY♪]: Operation tone enabled.

    [MUTE]: Operation tone muted.

    5673_76_other

  5. Push the crown back in to complete the setting operation.

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

Note that alarm and timer tones will still sound even while the operation tone is muted.

Back

Next