Module No. 5671

Measuring Elapsed Time

5671_26_STW

  1. Enter the Stopwatch Mode.

    2. Navigating Between Modes

  2. Push the crown back in.

  3. Use the operations below to measure elapsed time.

    4. fl_stw_A_btn_sstrsst_JAJP

  4. Press (B) to reset the elapsed time to all zeros.

    5. Pulling out the crown while an elapsed time measurement operation is in progress will reset the displayed value to all zeros.

Note

The (B) button operations below can be performed while an elapsed time measurement operation is in progress.

Connecting with a Paired Phone to Adjust the Watch’s Time

Time Adjustment Using a Time Calibration Signal

Pairing or Re-pairing the Watch with a Phone

Searching for a Paired Phone

Resetting the stopwatch to all zeros causes the second hand to move momentarily to 12 o’clock. After 10 seconds, it will start indicating the current timekeeping seconds.

The mode hand points to [STW] while an elapsed time measurement operation is in progress. The mode hand points to the Home City day of the week while the stopwatch is reset to all zeros.

Back

Next