Module No. 5660

Configuring Alarm Settings

  1. Enter the Alarm Mode.

    2. Navigating Between Modes

  2. Use (A) and (C) to display the number ([AL1] to [AL5]) of the alarm whose settings you want to change.

    3. 5660_36_ALM

  3. Pull out the crown.

    4. This causes the hours and minutes digits to flash.

    5660_37_ALM

  4. Rotate the crown to change the minute setting.

    5. The hour digit changes in sync with the minute digit change.

  5. Press (B).

    6. This causes the hours digits to flash.

    5660_38_ALM

  6. Rotate the crown to change the hour setting.

    7. If you are using 12-hour timekeeping, the time setting is indicated as [A] (a.m.) or [P] (p.m.).

    5660_39_ALM

  7. Push the crown back in to complete the setting operation.

Note

If you do not perform any operation for about three minutes while in the Alarm mode, the watch automatically returns to the Timekeeping Mode.

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

To stop the alarm

To stop the alarm after it starts to sound when an alarm time is reached, press any button.

Note

A beeper sounds for 10 seconds when an alarm time is reached.

Back

Next