Module No. 5660

Specifying the Barometric Pressure Unit

You can specify either hectopascals (hPa) or inches of mercury (inHg) as the display unit for barometric pressure values.

Important!

When Tokyo (TYO) is the Home City, the barometric pressure unit is fixed as hectopascals (hPa) and cannot be changed.

  1. Enter the Barometer Mode.

    2. Navigating Between Modes

  2. Pull out the crown.

    3. This displays the current barometric pressure.

    5660_Of_Set_BARO_comon

  3. Press (B).

    4. This causes [UNIT] to appear, with [hPa] or [inHg] flashing.

    5660_61_BARO

  4. Rotate the crown to select a barometric pressure unit.

    5. [hPa]: Hectopascals

    [inHg]: Inches of mercury

    5660_62_disp_BARO

  5. Push the crown back in to complete the setting operation.

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

Back

Next