Module No. 5658

Configuring Alarm Settings

  1. Enter the Alarm Mode.

    2. Navigating Between Modes

  2. Press (D) to scroll through alarm numbers ([AL1] to [AL5]) until the alarm you want to configure is displayed.

    3. 5658_25_ALM

  3. Hold down (A) for at least two seconds. Release the button when the hours digits start to flash.

    4. This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.

    5658_26_ALM

  4. Use (B) and (D) to change the hour setting.

    5. If you are using 12-hour timekeeping, [P] indicates p.m.

    5658_27_ALM

  5. Press (C).

    6. This causes the minutes digits to flash.

    5658_28_ALM

  6. Use (B) and (D) to set the minute setting.

  7. Press (A) to exit the setting screen.

    8. mark_ALM (Alarm) is shown on the display while an alarm is turned on.

    5658_29_ALM

  8. Hold down (C) for at least one second to return to the Timekeeping Mode.

To stop the alarm

Pressing any button while the beeper is sounding stops it.

Note

A beeper sounds for 10 seconds when an alarm time is reached.

The watch will automatically return from the Alarm Mode to the Timekeeping Mode if you do not perform any operation for about two or three minutes.

Back

Next