Module No. 5553
Configuring Alarm Settings
-
Enter the Alarm Mode.
-
Press (D) to scroll through alarms ([AL1] to [AL4], [SNZ]) until the one you want to configure is displayed.
-
Hold down (A) for at least two seconds. Release the button when the hour setting starts to flash.
-
Use (B) and (D) to change the hour setting.
-
Press (C).
-
Use (B) and (D) to set the minute setting.
-
Press (A) to complete the setting operation.

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Holding down (B) or (D) scrolls through settings at high speed.
If you are using 12-hour timekeeping, [P] indicates p.m.

This causes the minutes digits to flash.

[ALM] is shown on the display while an alarm is set.

Testing the alarm
In the Alarm Mode, hold down (D) to sound the alarm.
To stop the alarm
Pressing any button while the beeper is sounding stops it.
The snooze alarm operation sounds the alarm up to seven times at five-minute intervals. [SNZ] flashes on the display to indicate that a snooze alarm operation is in progress.
Any one of the operations below will stop an ongoing snooze alarm operation.
Turning off the snooze alarm
Displaying the snooze alarm setting screen
Displaying the Timekeeping Mode setting screen
Changing the DST setting of your Home Time in the World Time Mode
Changing your Home City in the World Time Mode
Note
A beeper sounds for 10 seconds when an alarm time is reached.
The watch will automatically return from the Alarm Mode to the Timekeeping Mode if you do not perform any operation for about two or three minutes.