Module No. 5553
Enabling the Button Operation Tone
Use the procedure below to enable or disable the tone that sounds when you press a button.
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least two seconds. Release the button when [SET] starts to flash.
-
Press (C) nine times.
-
Press (D) to select [KEY♪] or [MUTE].
-
Press (A) to complete the setting operation.
![5553_SET_comon](fig/5553_SET_comon_VPCVILrypmgcrz.png)
This causes [KEY♪] or [MUTE] to flash on the display.
![5553_33_other](fig/5553_33_other_VPCVILuryqkpth.png)
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
![5553_34_other](fig/5553_34_other_VPCVILjmpojzvu.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Note that alarm and timer tones will still sound even while the operation tone is muted.