Module No. 5411

Adjusting Hand and Day Indicator Alignment

1.Pull out the crown to the second click.

2.Hold down (B) for about five seconds, until the second hand moves to 12 o’clock.

This will start auto alignment of the hour hand, minute hand, second hand, and 24-hour hand.

  • After auto alignment is complete, the hands should be in the positions shown below.
5411_cor_01
  • If the 24-hour hand is off by 12 hours, hold down (A) for about two seconds. The 24-hour hand will move to 12 o’clock.

3.Press (C).

Confirm that the small hour hand and small minute hand are stopped at 12 o’clock.

5411_cor_02

4.If the small hour hand and small minute hand are not at 12 o’clock, rotate the crown to align them correctly.

5.Press (C).

Confirm that the mode hand is stopped at 12 o’clock.

5411_cor_03

6.If the mode hand is not at 12 o’clock, rotate the crown to align it correctly.

7.Press (C).

Confirm that the day indicator shows “1”.

5411_cor_04

8.If “1” is not shown for the day, rotate the crown until “1” is shown for the day.

9.Push the crown back in.