Module No. 3569

Button Operation Tone Setting

Use the procedure below to enable or disable the tone that sounds when you press a button.

If a setting screen (flashing setting) is displayed or if an alarm or other beeper operation is in progress, exit the setting screen or wait until the beeper operation is finished before trying to configure this setting.

  1. Hold down (C) for at least three seconds to toggle the operation tone between enabled and disabled.

    2. [MUTE] is displayed while the button operation tone is disabled.

    3569_30_Othe

    Pressing (C) to perform this operation also changes the watch mode.

Note

Note that alarm and timer tones will still sound even while the operation tone is muted.

Back

Next