Module No. 3568

Setting a Start Time

The start time can be set in 1-second units up to 60 minutes.

  1. Enter the Timer Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds.

    3. This displays the number of timer repeats (1 to 20) setting screen.

    3568_39_TMR_comon

  3. Use (A) and (C) to specify the number of timer repeats (Auto Repeat).

  4. Press (B).

  5. Use (A) and (C) to specify the position of the timer in the sequence.

    6. 3568_40_TMR_comon

  6. Press (B).

    7. This causes a cursor to appear under the minutes setting.

  7. Use (A) and (C) to change the minutes setting.

    8. 3568_41_TMR_comon

  8. Press (B).

    9. This moves the cursor to the seconds setting.

  9. Use (A) and (C) to change the seconds setting.

    10. 3568_42_TMR_comon

  10. Press (B).

  11. Use (A) and (C) to select whether or not you want to save your current settings.

    12. [YES]

    Saves current settings.

    [NO]

    Discards current settings.

    [RETURN]

    Returns to the number of repeats setting.

  12. Press (B) to complete the setting operation.

    13. After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the Timer Mode screen will re-appear.

Note

To exit the timer setting operation at any point, press (D) and advance to step 11.

The watch exits the setting operation automatically after about two or three minutes of non-operation.

Back

Next