Module No. 3564
Resetting Watch Settings
This section explains how to return the watch settings below to their initial factory defaults.
Watch Settings
Step Count
Stopwatch
Timer
Alarm
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least two seconds.
-
Press (C) twice.
-
Hold down (E) for at least five seconds. Release the button when [ALL] stops flashing.
This causes the current step reminder setting ([ON] or [OFF]) to flash on the display.
![3564_fl_StepRem_comon](fig/3564_fl_StepRem_comon_AHNIILvlfdhdlz.png)
This causes the seconds to flash.
![3564_14_MobileLink](fig/3564_14_MobileLink_AHNIILtxalnxlq.png)
![3564_51_other](fig/3564_51_other_AHNIILxuflscrw.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Resetting the watch will also delete information for pairing the watch with a phone, and unpair them.