Module No. 3564

Viewing Saved Data

You can use the operation below to view split times and lap times.

  1. Enter the Recall Mode.

    2. Navigating Between Modes

    This causes the latest measurement number and date to appear.

    3564_34_STW

  2. Press (A) to cycle through measurement numbers.

    3. Each time you press (A), the previous measurement number appears.

    3564_35_fl_STW

  3. Use (D) and (E) to display the record you want to view.

    4. [LAP]: Lap time

    [SPL]: Split time

    3564_36_fl_STW

    Split and lap times up to the one hour are shown in 1/100-second units. Subsequent measurements after one hour are shown in 1-second units.

Note

A record of the measured data is created and assigned a number for each measurement operation (from start to stop).

Back

Next