Module No. 3563

Viewing the Face in the Dark

The watch has a light that illuminates the face for viewing in the dark.

Turning On Illumination

Press (B) to turn on illumination.

Illumination will turn off automatically if an alarm starts to sound.

3563_07_LT_Intro

Important!

Frequent use of illumination will run down the battery.

Note

Display illumination is disabled when any one of the conditions below exists.

Alarm, timer alert, or other beeper sounding

Specifying the Illumination Duration

You can select either 1.5 seconds or three seconds as the illumination duration.

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

    3. 3563_fl_SET_HT_caps

  3. Press (C) 12 times.

    4. This will cause [1] or [3] to appear on the display.

    3563_08_LT_Intro

  4. Press (D) to toggle between the two illumination duration settings.

    5. [1]: 1.5-second illumination

    [3]: 3-second illumination

    3563_09_LT_Intro

  5. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next