Module No. 3561

Configuring Alarm Settings

  1. Enter the Alarm Mode.

    2. Navigating Between Modes

  2. Press (D) to scroll through alarm numbers ([1] to [5]) until the alarm you want to configure is displayed.

    3. 3561_10_AL

  3. Hold down (A) for at least one second.

    4. This causes the hours digits to flash.

    3561_11_AL

  4. Use (B) and (D) to change the hour setting.

    5. Holding down (B) or (D) scrolls through settings at high speed.

    If you use 12-hour timekeeping, [AM] indicates a.m. times, while [PM] indicates p.m. times.

    3561_12_AL

  5. Press (C).

    6. This causes the minutes digits to flash.

    3561_13_AL

  6. Use (B) and (D) to set the minute setting.

  7. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Testing the alarm

In the Alarm Mode, hold down (D) to sound the alarm.

To stop the alarm

To stop the alarm after it starts to sound when an alarm time is reached, press any button.

Note

A beeper will sound for 10 seconds to let you know when the alarm time is reached.

The watch will automatically return to the Timekeeping Mode from the Alarm Mode after two or three minutes of non-operation.

Back

Next