Module No. 3559

Enabling the Button Operation Tone

Use the procedure below to enable or disable the tone that sounds when you press a button.

If a setting screen (flashing setting) is displayed or if an alarm or other beeper operation is in progress, exit the setting screen or wait until the beeper operation is finished before trying to configure this setting.

  1. Hold down (C) for at least three seconds to toggle the operation tone between enabled and disabled.

  2. [MUTE] is displayed while the button operation tone is disabled.

    3559_39_Other

    Pressing (C) to perform this operation also changes the watch mode.

Note

Note that alarm, timer, and stopwatch Auto Start tones will continue to sound even if you disable the operation tone.

Back

Next