Module No. 3559

There are various alarm variations, and the variation that is set depends on the hour, minute, month, and day settings you configure.

Configuring Some of the Settings (hour, minute, month, day)

All Settings: Hour, Minute, Month, Day

The alarm sounds once at the specified time on the specified date.

1. Enter the Alarm Mode.

Navigating Between Modes

2. Press (D) to scroll through alarms ([1], [2], [SNZ]) until the one you want to configure is displayed.



3. Hold down (A) for at least one second.

This causes the hours digits to flash.



4. Use (C) to display the setting you want to change.

Each press of (C) cycles through settings in the sequence shown below.



5. Use (B) and (D) to change the selected setting.

Holding down (B) or (D) scrolls through settings at high speed.

[-] is displayed for the month and [- -] is displayed for the day if nothing is specified for these settings.

If you are using 12-hour timekeeping, [P] indicates a p.m. time when you are setting the hour.



6. Repeat steps 4 and 5 to configure time and date settings.

7. Press (A) to complete the setting operation.

Testing the alarm

In the Alarm Mode, hold down (D) to sound the alarm.

To stop the alarm

To stop the alarm after it starts to sound when an alarm time is reached, press any button.

Snooze causes the alarm to sound up to seven times, at five-minute intervals. To cancel a snooze alarm, turn [SNZ] off.