Module No. 3559

Adjusting the Current Time Setting

Use the procedure below to adjust the current date and time settings, and to specify the Home Time offset.

Setting Your Home Time Offset

Specify the location where you are using this watch. If your location observes Daylight Saving Time, you can configure the time setting accordingly.

  1. Enter the Timekeeping Mode.

  2. Hold down (A) for at least one second. Release the button when the seconds start to flash.

  3. 3559_Sec_SET_comon
  4. Press (C).

  5. Use (D) to change the summer time setting.

  6. [OFF]
    The watch always indicates standard time.

    [On]
    The watch always indicates summer time.

    3559_06_ATDS
  7. Press (C).

  8. Use (B) and (D) to change the Home Time offset.

  9. Holding down (B) or (D) scrolls through settings at high speed.

    For information about the home time offsets (time zones), refer to the table below.

  10. Press (A) twice to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Setting the Time/Date

  1. Enter the Timekeeping Mode.

  2. Hold down (A) for at least one second. Release the button when the seconds start to flash.

  3. 3559_Sec_SET_comon
  4. Use (C) to display the setting you want to change.

  5. Each press of (C) cycles through settings in the sequence shown below.

    fl_Date_Time_seting_Item_09
  6. Configure the date and time settings.

  7. While the seconds are flashing, pressing (D) will reset them to 00. 1 is added to the minutes when the current seconds count is between 30 and 59 seconds.

    For all the other settings, use (B) and (D) to change the flashing setting.
    Holding down (B) or (D) scrolls through settings at high speed.

  8. Repeat steps 3 and 4 to select time and date settings.

  9. Press (A) twice to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Switching between 12-hour and 24-hour Timekeeping

You can specify either 12-hour format or 24-hour format for the time display.

  1. Enter the Timekeeping Mode.

  2. Press (D) to select 12-hour or 24-hour timekeeping.

  3. Each press of (D) toggles between 12-hour and 24-hour timekeeping.

    [P] is displayed during p.m. times while 12-hour timekeeping is being used.

    3559_07_fl_ATDS

Back

Next