Module No. 3552
Setting the Countdown Start Time
The start time can be set in 1-second units up to 60 minutes.
If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.
-
Enter the Timer Mode.
-
Hold down (A) for at least two seconds.
-
Use (B) and (D) to change the timer minutes setting.
-
Press (C).
-
Use (B) and (D) to change the seconds setting.
-
Press (A) to complete the setting operation.
This causes the minutes digits to flash.
![3552_43_TMR](fig/3552_43_TMR_NHCXILikvurpgn.png)
Holding down (B) or (D) scrolls through settings at high speed.
This causes the seconds digits to flash.
![3552_44_TMR](fig/3552_44_TMR_NHCXILzwbiagmm.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Setting a start time of 00’00” performs a countdown of 60 minutes.