Module No. 3545

Enabling the Button Operation Tone

Use the procedure below to enable or disable the tone that sounds when you press a button.

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the city code starts to flash.

    3. 3545_SET_HomeCity_common

  3. Press (C) nine times.

    4. This causes [KEY♪] or [MUTE] to flash on the display.

    3545_30_Other

  4. Press (D) to select [KEY♪] or [MUTE].

    5. [KEY♪]: Operation tone enabled.

    [MUTE]: Operation tone disabled.

    3545_31_Other

  5. Press (A) to complete the setting operation.

    6. [icon_MUTE_3545] is displayed while the operation tone is muted.

    3545_32_Other

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Note that alarm and timer tones will still sound even while the operation tone is muted.

Back

Next