Module No. 3531

Correcting Data

  1. Enter the Data Bank Mode.

    2. Navigating Between Modes

  2. Use (B) and (D) to display the data you want to correct.

  3. Hold down (A) for at least one second.

    4. This causes the first character of the name to flash.

  4. Use (C) to select the character you want to change.

  5. Use (B) and (D) to change the flashing character.

  6. Repeat steps 4 and 5 to correct the data.

  7. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next