Module No. 3527

Setting the Time

The countdown start time can be set in 1-second units up to 24 hours.

If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.

Using the Timer

  1. Enter the Timer Mode.

    2. Navigating Between Modes

  2. Press (A).

    3. This causes the hours digits to flash.

    3527_09_TMR

  3. Use (D) to change the timer hour setting.

    4. Holding down (D) scrolls through settings at high speed.

  4. Press (C).

    5. This causes the minutes digits to flash.

    3527_10_TMR

  5. Use (D) to change the timer minute setting.

  6. Press (C).

    7. This causes the seconds digits to flash.

    3527_11_TMR

  7. Use (D) to change the timer seconds setting.

  8. Press (L) to select Repeat Timer or Auto Repeat Timer.

    9. Each press of (L) toggles between Repeat Timer and Auto Repeat Timer.

    [AUTO] is displayed while Auto Repeat is enabled.

    3527_12_TMR

  9. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Setting a start time of [0:00’00] will perform a countdown of 24 hours.

Back

Next