Module No. 3527

Adjusting the Current Time Setting

Use the procedures in this section to adjust the date and time settings.

Setting the Time/Date

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Press (A).

    3. This causes the seconds to flash.

    3527_TimeSet_seconds

  3. Keep pressing (C) until the setting you want to change is flashing.

    4. Each press of (C) moves the flashing to the next setting in the sequence shown below.

    fl_Date_Time_seting_Item_02

  4. Configure the date and time settings.

    5. While the seconds are flashing, pressing (D) will reset them to 00. 1 is added to the minutes when the current seconds count is between 30 and 59 seconds.

    For all the other values, use (D) to change the flashing setting.
    Holding down (D) scrolls through settings at high speed.

  5. Repeat steps 3 and 4 to select time and date settings.

  6. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Switching between 12-hour and 24-hour Timekeeping

You can specify either 12-hour format or 24-hour format for the time display.

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Press (A).

    3. This causes the seconds to flash.

    3527_TimeSet_seconds

  3. Press (L) to select 12-hour or 24-hour timekeeping.

    4. Each press of (L) toggles between 12-hour and 24-hour timekeeping.

    [P] is displayed during p.m. times while 12-hour timekeeping is being used.

    3527_05_fl_ATDS

  4. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next