Module No. 3527
Configuring Alarm Settings
There are various alarm variations, and the variation that is set depends on the hour, minute, month, and day settings you configure.
Configuring Some of the Settings (hour, minute, month, day)
Hour and Minute Settings Only
The alarm sounds every day at the specified time.
Month, Hour and Minute Settings Only
The alarm sounds every day of the specified month at the specified time.
Day, Hour and Minute Settings Only
The alarm sounds every month at the specified time on the specified day.
All Settings: Hour, Minute, Month, Day
The alarm sounds once at the specified time on the specified date.
-
Enter the Alarm Mode.
-
Press (A).
-
Keep pressing (C) until the setting you want to change is flashing.
-
Use (D) to change the value.
-
Repeat steps 3 and 4 to select time and date settings.
-
Press (A) to complete the setting operation.
This causes the hours digits to flash.
Each press of (C) moves the flashing to the next setting in the sequence shown below.
Holding down (D) scrolls through settings at high speed.
[-] is displayed for the month and [- -] is displayed for the day if nothing is specified for these settings.
While you are setting the timekeeping hour, [P] (p.m.) is displayed during p.m. times if you are using 12-hour timekeeping, while [24H] is displayed if you are using 24-hour timekeeping.
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
To stop the alarm
To stop the alarm after it starts to sound when an alarm time is reached, press any button.
Note
A beeper sounds for 20 seconds to let you know when the alarm time is reached.
If flash alert is enabled, display illumination flashes along with the alarm beeper and the hourly time signal. Pressing any button to stop the alarm beeper also stops the flash alert operation.