Module No. 3523
Setting the Time
The countdown start time can be set in 1-second units up to 24 hours.
If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.
-
Enter the Timer Mode.
-
Press (A).
-
Use (B) to change the timer hour setting.
-
Press (C).
-
Use (B) to change the timer minute setting.
-
Press (C).
-
Use (B) to change the timer seconds setting.
-
Press (D) to select Repeat Timer or Auto Repeat Timer.
-
Press (A) to complete the setting operation.
This causes the hours digits to flash.
![3523_09_TMR](fig/3523_09_TMR_UQIDILvthqxbmw.png)
Holding down (B) scrolls through settings at high speed.
This causes the minutes digits to flash.
![3523_10_TMR](fig/3523_10_TMR_UQIDILfhgmlvij.png)
This causes the seconds digits to flash.
![3523_11_TMR](fig/3523_11_TMR_UQIDILvtuxbpfn.png)
Each press of (D) toggles between Repeat Timer and Auto Repeat Timer.
[AUTO] is displayed while Auto Repeat is enabled.
![3523_12_TMR](fig/3523_12_TMR_UQIDILtibnlbpa.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Setting a start time of [0:00’00] will perform a countdown of 24 hours.