Module No. 3522
Configuring Alarm Settings
There are various alarm variations, and the variation that is set depends on the hour, minute, month, and day settings you configure.
Configuring Some of the Settings (hour, minute, month, day)
Hour and Minute Settings Only
The alarm sounds every day at the specified time.
Month, Hour and Minute Settings Only
The alarm sounds every day of the specified month at the specified time.
Day, Hour and Minute Settings Only
The alarm sounds every month at the specified time on the specified day.
All Settings: Hour, Minute, Month, Day
The alarm sounds once at the specified time on the specified date.
-
Enter the Alarm Mode.
-
Press (D) to scroll through alarms ([1], [2], [SNZ]) until the one you want to configure is displayed.
-
Hold down (A) for at least two seconds.
-
Use (C) to display the setting you want to change.
-
Use (B) and (D) to change the selected setting.
-
Repeat steps 4 and 5 to configure time and date settings.
-
Press (A) to complete the setting operation.
![3522_11_AL](fig/3522_11_AL_VPCVILaydgjlpp.png)
This causes the hours digits to flash.
![3522_12_AL](fig/3522_12_AL_VPCVILeavdfmuc.png)
Each press of (C) cycles through settings in the sequence shown below.
![fl_ALM_setting](fig/fl_ALM_setting_VPCVILpkdmtdzz.png)
Holding down (B) or (D) scrolls through settings at high speed.
[-] is displayed for the month and [- -] is displayed for the day if nothing is specified for these settings.
If you are using 12-hour timekeeping, [P] indicates a p.m. time when you are setting the hour.
![3522_13_AL](fig/3522_13_AL_VPCVILgpojvvdv.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Testing the alarm
In the Alarm Mode, hold down (D) to sound the alarm.
To stop the alarm
To stop the alarm after it starts to sound when an alarm time is reached, press any button.
Snooze causes the alarm to sound up to seven times, at five-minute intervals. To cancel a snooze alarm, turn [SNZ] off.
Note
A beeper will sound for 10 seconds to let you know when the alarm time is reached.
The watch will automatically return to the Timekeeping Mode from the Alarm Mode after two or three minutes of non-operation.