Module No. 3522
Setting the Time
The countdown start time can be set in 1-minute units up to 24 hours.
If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.
-
Enter the Timer Mode.
-
Hold down (A) for at least one second.
-
Use (B) and (D) to change the timer hours setting.
-
Press (C).
-
Use (B) and (D) to change the timer minutes setting.
-
Press (C).
-
Press (D) to select Repeat Timer or Auto Repeat Timer.
-
Press (C).
-
Press (D) to select [♪ON] or [♪OFF] as the beep setting.
-
Press (A) to complete the setting operation.
This causes the hours digits to flash.
![3522_32_TMR](fig/3522_32_TMR_VPCVILutxlhpyt.png)
Holding down (B) or (D) scrolls through settings at high speed.
This causes the minutes digits to flash.
![3522_33_TMR](fig/3522_33_TMR_VPCVILxpqqicsr.png)
This causes [] (Repeat Timer) or [
] (Auto Repeat Timer) to flash on the display.
Each press of (D) toggles between [] (Repeat Timer) and [
] (Auto Repeat Timer).
![3522_34_TMR](fig/3522_34_TMR_VPCVILxpryxjwe.png)
[♪ON]: Tone enabled.
[♪OFF]: Tone disabled.
![3522_35_TMR](fig/3522_35_TMR_VPCVILhyohnkmo.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Setting a start time of [0:00 00] will perform a countdown of 24 hours.