Module No. 3522
Adjusting the Current Time Setting
Use the procedures in this section to adjust the date and time settings.
Setting the Time/Date
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least one second. Release the button when the seconds start to flash.
-
Use (C) to display the setting you want to change.
-
Configure the date and time settings.
-
Repeat steps 3 and 4 to select time and date settings.
-
Press (A) twice to complete the setting operation.
![3522_Sec_SET_comon](fig/3522_Sec_SET_comon_VPCVILveuxqtqg.png)
Each press of (C) cycles through settings in the sequence shown below.
![fl_Date_Time_seting_Item_09](fig/fl_Date_Time_seting_Item_09_VPCVILnemcmyyp.png)
While the seconds are flashing, pressing (D) will reset them to 00. 1 is added to the minutes when the current seconds count is between 30 and 59 seconds.
For all the other settings, use (B) and (D) to change the flashing setting.
Holding down (B) or (D) scrolls through settings at high speed.
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Configuring the Summer Time Setting
If you are in an area that observes summer time, you can also configure a summer time setting.
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least one second. Release the button when the seconds start to flash.
-
Press (C).
-
Use (D) to change the summer time setting.
-
Press (A) twice to complete the setting operation.
![3522_Sec_SET_comon](fig/3522_Sec_SET_comon_VPCVILveuxqtqg.png)
[OFF]
The watch always indicates standard time.
[On]
The watch always indicates summer time.
![3522_06_ATDS](fig/3522_06_ATDS_VPCVILodnutggo.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Switching between 12-hour and 24-hour Timekeeping
You can specify either 12-hour format or 24-hour format for the time display.
-
Enter the Timekeeping Mode.
-
Press (D) to select 12-hour or 24-hour timekeeping.
Each press of (D) toggles between 12-hour and 24-hour timekeeping.
[P] is displayed during p.m. times while 12-hour timekeeping is being used.
![3522_07_fl_ATDS](fig/3522_07_fl_ATDS_VPCVILnvmbbsvw.png)