Module No. 3521

Configuring Alarm Settings

  1. Enter the Alarm Mode.

    2. Navigating Between Modes

  2. Press (D) to scroll through alarms ([1] to [4], [SNZ]) until the one you want to configure is displayed.

    3. 3521_16_AL

  3. Hold down (A) for at least two seconds.

    4. This causes the hours digits to flash.

    3521_17_AL

  4. Use (B) and (D) to change the hour setting.

    5. Holding down (B) or (D) scrolls through settings at high speed.

    If you are using 12-hour timekeeping, [P] indicates p.m.

    3521_18_AL

  5. Press (C).

    6. This causes the minutes digits to flash.

    3521_19_AL

  6. Use (B) and (D) to set the minute setting.

  7. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Testing the alarm

In the Alarm Mode, hold down (D) to sound the alarm.

To stop the alarm

To stop the alarm after it starts to sound when an alarm time is reached, press any button.

Snooze causes the alarm to sound up to seven times, at five-minute intervals. To cancel a snooze alarm, turn [SNZ] off.

Turning Off an Alarm or the Hourly Time Signal

Note

A beeper will sound for 10 seconds to let you know when the alarm time is reached.

The watch will automatically return to the Timekeeping Mode from the Alarm Mode after two or three minutes of non-operation.

Back

Next