Module No. 3519
Configuring Alarm Settings
-
Enter the Alarm Mode.
-
Press (D) to scroll through alarm numbers ([AL1] to [AL5]) until the alarm you want to configure is displayed.
-
Hold down (A) for at least two seconds. Release the button when the hours digits start to flash.
-
Use (B) and (D) to change the hour setting.
-
Press (C).
-
Use (B) and (D) to set the minute setting.
-
Press (A) to exit the setting screen.
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Holding down (B) or (D) scrolls through settings at high speed.
If you are using 12-hour timekeeping, [P] indicates p.m.
This causes the minutes digits to flash.
[ALM] (alarm) is shown on the display while an alarm is turned on.
Note
A beeper sounds for 10 seconds when an alarm time is reached.
The watch will automatically return from the Alarm Mode to the Timekeeping Mode if you do not perform any operation for about two or three minutes.
Testing the alarm
In the Alarm Mode, hold down (D) to sound the alarm.
To stop the alarm
Pressing any button while the beeper is sounding stops it.