Module No. 3516

Turning Off an Alarm

To stop an alarm sound and/or vibration operation, perform the steps below to turn it off.

To reactivate an alarm sound and/or vibration operation, turn it back on.

Note

An indicators is displayed while any one of the alarms is turned on.

The alarm indicator is not displayed while all of the alarms are turned off.

3516_064_ALM

  1. Display the current time screen.

    2. Watch Mode

  2. Hold down (C) for at least two seconds.

    3. This enters the Control Mode.

  3. Use (C) to select [SETTING].

    4. 3516_SETTING

  4. Press (A).

    5. This displays the setting menu screen.

    3516_Set_Menu_caps

  5. Use (C) to move the pointer to [WATCH SETTINGS].

  6. Press (A).

    7. This displays the watch setting screen.

  7. Use (C) to move the pointer to [ALARM].

  8. Press (A).

  9. Use (C) to move the pointer to the alarm you want to turn off.

    10. 3516_ALM_set

  10. Press (A).

  11. Use (C) to select [OFF].

  12. Press (A) to complete the setting operation.

    13. After the setting operation is complete, a check mark appears for a few seconds, and then the alarm selection screen re-appears.

  13. Hold down (D) for at least one second to return to the current time screen.

    14. Turning off all alarms causes [ALM] (alarm) to disappear from the display.

    3516_065_ALM

Note

If [ALM] (alarm) is still displayed after you turn off an alarm, it means at least one of the other alarms is still turned on. To turn off all alarms, repeat steps 8 through 11 until the [ALM] (alarm) indicator is no longer displayed.

If [ALM] (alarm) is still displayed even after you turn off all the alarms, it means the smart alarm is turned on. Turn off the smart alarm.

Turning Off Smart Alarm

Back

Next