Module No. 3509

Setting the Countdown Start Time

The countdown start time can be set in 1-second units up to 24 hours.

If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.

Using the Timer

  1. Enter the Timer Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds.

    3. This causes the hours digits to flash.

    3509_30_TMR

  3. Use (B) and (D) to change the timer hours setting.

    4. Holding down (B) or (D) scrolls through settings at high speed.

  4. Press (C).

    5. This causes the minutes digits to flash.

    3509_31_TMR

  5. Use (B) and (D) to change the timer minutes setting.

  6. Press (C).

    7. This causes the seconds digits to flash.

    3509_32_TMR

  7. Use (B) and (D) to change the seconds setting.

  8. Press (A) to exit the setting screen.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Setting a start time of [0:00 00] will perform a countdown of 24 hours.

Back

Next