Module No. 3496
Configuring Alarm Settings
-
Enter the Alarm Mode.
-
Use (D) to display the alarm screen (alarm number [1] to [4] or [SNZ]) whose setting you want to change.
-
Hold down (A) for at least two seconds.
-
Use (B) and (D) to change the hour setting.
-
Press (C).
-
Use (B) and (D) to change the minute setting.
-
Press (A) to exit the setting screen.
![3496_19_ALM](fig/3496_19_ALM_UQIDILvoapythh.png)
This causes the hours digits to flash.
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
![3496_20_ALM](fig/3496_20_ALM_UQIDILgknrscro.png)
Holding down (B) or (D) scrolls through settings at high speed.
If you are using 12-hour timekeeping, [P] indicates p.m.
![3496_21_ALM](fig/3496_21_ALM_UQIDILwitrjxhr.png)
This causes the minutes digits to flash.
![3496_22_ALM](fig/3496_22_ALM_UQIDILwcgbirhm.png)
To stop the alarm
To stop the alarm after it starts to sound when an alarm time is reached, press any button.
Snooze causes the alarm to sound up to seven times, at five-minute intervals. To cancel a snooze alarm, turn [SNZ] off.
Note
A beeper will sound for 10 seconds to let you know when the alarm time is reached.
The watch will automatically return to the Timekeeping Mode from the Alarm Mode after two or three minutes of non-operation.