Module No. 3496
Setting the Time
The countdown start time can be set in 1-second units up to 24 hours.
If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.
-
Enter the Timer Mode.
-
Hold down (A) for at least two seconds.
-
Use (B) and (D) to change the timer hours setting.
-
Press (C).
-
Use (B) and (D) to change the timer minutes setting.
-
Press (C).
-
Use (B) and (D) to change the seconds setting.
-
Press (A) to exit the setting screen.
This causes the hours digits to flash.
![3496_28_TR](fig/3496_28_TR_UQIDILfosnawlb.png)
Holding down (B) or (D) scrolls through settings at high speed.
This causes the minutes digits to flash.
![3496_29_TR](fig/3496_29_TR_UQIDILduampuba.png)
This causes the seconds digits to flash.
![3496_30_TR](fig/3496_30_TR_UQIDILyypwytdp.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Setting a start time of [0:00 00] will perform a countdown of 24 hours.