Module No. 3493

Configuring Alarm Settings

  1. Enter the Alarm Mode.

  2. Use (D) to display the alarm screen (alarm number [1] to [4] or [SNZ]) whose setting you want to change.

  3. 3493_18_ALM
  4. Hold down (A) for at least two seconds.

  5. This causes the hours digits to flash.

    While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

    3493_19_ALM
  6. Use (B) and (D) to change the hour setting.

  7. Holding down (B) or (D) scrolls through settings at high speed.

    If you are using 12-hour timekeeping, [P] indicates p.m.

    3493_20_ALM
  8. Press (C).

  9. This causes the minutes digits to flash.

    3493_21_ALM
  10. Use (B) and (D) to change the minute setting.

  11. Press (A) to exit the setting screen.

To stop the alarm

To stop the alarm after it starts to sound when an alarm time is reached, press any button.

Snooze causes the alarm to sound up to seven times, at five-minute intervals. To cancel a snooze alarm, turn [SNZ] off.

Note

A beeper will sound for 10 seconds to let you know when the alarm time is reached.

The watch will automatically return to the Timekeeping Mode from the Alarm Mode after two or three minutes of non-operation.

Back

Next