Module No. 3493

Enabling and disabling Auto Receive

You can stop auto receive by disabling the Auto Receive setting.

Note

While the Home City setting is one where time signal reception is possible, you can enable or disable auto receive as required.

Time Signal Reception Ranges

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

    3. 3493_RCVD_fl_SET_HT_caps

  3. Press (C) 13 times.

    4. This causes [On] or [OFF] to flash on the display.

    3493_09_ATDS

  4. Press (D) to toggle between on and off.

    5. [On]: Auto Receive enabled.

    [OFF]: Auto Receive disabled.

  5. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next