Module No. 5699

Adjusting the Current Analog Time Setting

  1. Enter the Hand Setting Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least one second. Release the button when the current time starts to flash on the digital display.

    3. 5699_07_ATDS

  3. Press (D).

    4. Each press advances the time setting 1/3 of a minute (20 seconds).

    Holding down (D) advances the hands at high speed.

    Pressing (B) and (D) at the same time advances the time setting up to 12 hours at high speed. To stop the high-speed operation at any time, press any button.

  4. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next