You can perform an operation on the watch that will cause your phone to emit sound to help you remember where you left it. The phone finder operation forces the phone to emit a tone, even if it is in the silent mode.

To use the watch to find your phone

1.

Check to confirm that the Bluetooth icon () is on the watch display.

2.

In the Timekeeping Mode, hold down the A button for about one second.

• This will display the screen shown below and sound a tone on the phone.
  
• When the control indicator is displayed, the watch is in the Control Mode. In this case, hold down the B button for about three seconds to exit the Control Mode. Next, perform step 2 of this procedure.

3.

The tone produced by the phone continues for about one minute. If the watch's display shows a flashing Tap indicator, you can stop the tone by double-tapping the watch display. You can also stop it by performing some operation on the phone.