Support

G-SQUAD PRO

GSW-H1000

Using Surfing

You can record your surfing start times and end times. You can also keep a memo of how many rides you take. (Since the watch is used in water while surfing, location information is not recorded.)

Touch Panel Disabled

With the Surfing Activity, touch panel operation is disabled because the activity is conduced in water.
Use buttons to perform the operations below.

  1. 1Upper (START) button
  2. 2Lower (APP) button

To start Surfing

  1. STEP1Select the Surfing item and then press the up (START) button.

  2. STEP2Next, after you have entered the water and you are ready to ride a wave, press the upper (GO!) button again.

  3. STEP3This enters the Surfing recording mode, so you can start surfing.

Examples Surfing Recording Mode Display

  1. 1Current time and PAUSE button
  2. 2Time (elapsed)
  3. 3Tide Graph

To exit Surfing

  1. STEP1After you reach shore while the watch is in the Surfing recording mode described above, press the upper button to pause recording.

  2. STEP2Next, hold down the lower button for at least two seconds to stop Surfing recording.

  3. STEP3Either save or discard the recorded data as desired.

Riding Waves

With the Surfing Activity, you can record the amount of time you spend riding each wave.

  1. STEP1In the Surfing recording mode described above, press the lower bottom each time you are about to ride each wave.

  2. STEP2The number of wave rides is incremented.

    • For example, if you press the lower button 10 times while in the water, it will be interpreted as 10 rides.