Installation Using a USB Memory Device

 

* Take great care that your projector is operating in a stable environment during installation. Power failures or removing the USB memory device being used for the installation will disable the projector’s network function.
* Note also that installing firmware that is intended for a different projector model will prevent normal operation of the network function and block future firmware updates. ​
   The repair will be subjest to a fee.

[Getting Ready]

  1. Extract the file you downloaded. This creates the “CASIO_N_0.02.27.9.03.enc” file.
    * Applicable models: XJ-F21XN/F211WN/UT312WN/UT352WN/S400UN/S400WN
  2. Copy the extracted file to the root directory (immediately below the drive level) on a USB memory device.
    •Ensure that the root directory contains only the copied file.
    •Do not rename the file.
  3. Disconnect the projector’s power cord.

[Installation procedure]

  1. Plug the USB memory device into the projector.
  2. Use the power cord to connect the projector to the power outlet.
    •The projector starts up in standby mode.
  3. Press and hold the [ENTER] on the projector until the POWER/STANDBY LED starts flashing red.
  4. After approximately 45 seconds, installation begins.
    • Installation takes around 11 minutes.
  5. Installation is complete when the STATUS LED changes from flashing green to steadily lit green.
  6. Once installation is completed, disconnect the power cord and USB memory device from the projector.

[LED states during installation]

[If an error occurs]

  • A) Timeout error
  • B) Other error, such as USB memory device not inserted, wrong file name, or file not found on USB memory device   * If an error occurs, disconnect the power cord and USB memory device from the projector and try again.

[LED states for errors]