CUT: Values are cut off to the number of decimal places specified by the current Decimal Place Selector setting

UP: Values are rounded up to the number of decimal places specified by the current Decimal Place Selector setting

5/4: Values are rounded off (0,1,2,3,4 are cut off; 5,6,7,8,9 are rounded up) to the number of decimal places specified by the current Decimal Place Selector setting

4,3,2,1,0: Specifies the number of decimal places as 4,3,2,1,0

ADD2: 2 decimal places are assumed for entries and results of all addition and subtraction operations. Entering 2 only results in a value of 0.02 for the entry. If you use the "." key during entry of a value, the decimal point is included at the place you specify. This mode is no effect on multiplication and division operations.