You can use the procedures in this section to adjust image quality, to adjust the alignment of a Full 360° image, and to perform other editing operations. Edits are maintained until the Software is exited.
Using the Editing Screen
1. Start up the Software.
2. On the image menu, click the image you want to edit.
3. Click the edit icon.
This displays the editing screen.
4. Select the function you want to use by clicking its icon, and then edit the image as required.
5. After all of the edits are the way you want, click “OK”.
• To cancel editing and return to the main screen without saving your edits, click the back icon any time before clicking “OK”.
The operations you can perform with the editing screen are listed below.
• Adjust image quality.
• When there is a Full 360° image displayed, change the boundary line where the two image join together.
• When there is a Full 360° image displayed, adjust the alignment between the two images.
• When playing back a Full 360° movie, adjust the playback timing of the two movies.
• Trim the beginning and end of a movie.
Adjusting Image Quality
Use the procedure below to adjust the tint and brightness of an image.
1. On the editing screen, click the image quality adjustment icon.
2. Drag the sliders to adjust the tint and brightness of the image.
• In the case of a Full 360° image, there are two controllers. Hovering the mouse pointer over either of the controllers will cause the corresponding image to be highlighted for a few seconds.
Changing the Full 360° Image Boundary Line
A Full 360° image is created by combining two images into a spherical view. When there is a Full 360° image displayed, you can use the procedure below to change the boundary line where the two images join together.
1. On the editing screen, click the boundary line adjustment icon.
2. Click the boundary line you want to display.
Adjusting the Alignment between the Two Images of a Full 360° Image
When the two images that make up a Full 360° image do not align properly where they join together, you can use the procedure below to rotate the images and adjust their alignment.
1. On the editing screen, click the alignment adjustment icon.
2. Use the adjustment buttons (upward and downward) to adjust the alignment of the images.
Adjusting the Playback Timing of a Movies
When the playback timing of the two movies that make up a Full 360° movie are out of sync, you can use the procedure below to adjust it. During playback of a Full 360° Movie, the audio of only one of the movies is played back. You can specify which of the movies’ audio should play back.
1. On the editing screen, click the playback position adjustment icon.
2. Use the adjustment buttons ((upward and downward) to adjust the playback timing of the movies.
Trimming the Beginning and End of a Movie
Use the procedure below to trim the beginning and end of a movie. In the case of a Full 360° movie, both of the movies are cut.
1. On the editing screen, click the movie cut icon.
2. You can change the trim locations by dragging the handles of the controller area seek bar left or right.
