General Performance, Recording Conditions, Memory Card
- Q16
- Is initial Bluetooth pairing between the camera and controller necessary for operation?
- A16
- There is no need for pairing with the EX-FR100L.
The camera and controller come to you pre-paired at the factory, so initial pairing is not required and they should connect with each other automatically using Bluetooth wireless technology whenever you turn them on.
However, after having the camera repaired or serviced, you may need to re-pair the camera and controller in order to establish a connection between them. In this case, You can use the procedure below to re-pair the camera and controller. This will start the pairing operation required for Bluetooth connection.
IMPORTANT!
• Your camera has Bluetooth wireless technology communication functionality built in. Avoid operating the camera (including camera standalone operations) inside of aircraft or anywhere else where wireless data communication is restricted.
NOTE
• After having the camera repaired or serviced, you may need to re-pair the camera and controller in order to establish a connection between them.
If you do, procedure below to re-pair.
This starts the pairing operation required for Bluetooth wireless technology connection.
Procedure
1. Remove the memory card from the camera.
2. While holding down the camera shutter button, hold down the power button for at least one second.
This will cause the camera's operation lamp to flash amber.
3. While holding down the controller shutter button, hold down its power button for at least six seconds.
The operation lamp on the controller will flash amber, and then the pairing operation required for Bluetooth connection will start.
When registration is successful, the camera's date and time setting screen will appear on the controller.