Multi Camera Mode

Q6
What should I do to register an additional camera on a controller?
A6
To use a second camera, you need to register it on the controller.

Procedure
1. If there is a memory card loaded in the second camera, remove it.
2. On the menu screen, touch the "Setup" tab.
3. Touch "Multi Camera".
4. Touch "Add".
5. Touch "Start" to start registration of the camera.
6. While holding down the shutter button of the camera you want to register, hold down the power button for at least one second.
   This will cause the operation lamp to flash orange to indicate that camera registration has started.
   When the camera is registered successfully, a message appears and then the Multi Image screen appears.

NOTE
• Up to two cameras can be registered at one time. To add a new camera while two cameras are already registered, you will need to first unregister one of the registered cameras.
• A message will appear if camera registration fails, and then the display will return to the screen that was shown before you touched the "Setup" tab. If this happens,
perform the camera registration procedure again from step 1.
• You can also use the procedure below to register a camera on a controller.
  1. If the camera has a memory card loaded, remove it.
  2. While holding down the camera shutter button, hold down the power button button for at least one second.
  3. While holding down the controller shutter button, hold down the power button for at least six seconds.
      This will cause the operation lamps of the camera and the controller to flash orange to indicate that camera registration has started.

How useful was this information?

SEND