You can use the procedure below to shoot a self-portrait by operating the camera from a slightly remote location.
With the EX-10, EX-100, EX-ZR50, or EX-ZR850, you can use any one of the recording modes below to shoot with Remote Capture. Perform the required operation on the camera to select the recording mode you want to use. You cannot change the recording mode using EXILIM Remote operations.
• Program Auto
• Pemium Auto Pro
With the EX-10, EX-100
, or EX-ZR850, you also can use the recording modes below.
• A (Aperture Priority) mode
• S (Shutter Speed Priority) mode
• M (Manual Exposure) mode
With the EX-TR15, EX-TR17, EX-TR35, EX-TR37,
EX-TR50, or EX-TR52, images are recorded using Premium Auto Pro when shooting with Remote Capture. Shooting with Remote Capture is not supported using BEST SHOT or other recording modes.
Procedure
1. EX-10, EX-100, EX-ZR50, or EX-ZR850: With the camera in any one of the recording modes listed in the table above, perform the following operation: MENU
REC MENU tab
Remote Capture
RemoteStart
[SET].
EX-TR15, EX-TR17, EX-TR35, EX-TR37,
EX-TR50, or EX-TR52: In the REC mode, touch the [Remote Capture] icon.
2. On your smartphone, start up the EXILIM Remote app.
This will establish a connection between the smartphone and your camera, which will cause the camera's back lamp to light green.
• About 60 seconds after your camera establishes a connection with the smartphone, the camera's monitor screen will go blank.
• If the message "Connect your phone to the access point below." remains on the camera's monitor screen, change the smartphone's Wi-Fi settings so your camera is selected for connection.
3. Compose the image on your smartphone's screen as you shoot.
• After you are finished using Remote Capture, exit the app on your smartphone.
NOTE
• To use any of these functions, you need to install the EXILIM Remote app on your smartphone.
• The Movie Quality is always STD (640x480) when shooting with Remote Capture.
• The camera’s Handsfree Mode cannot be used while shooting with this function.
• High Speed CS and Prerecord CS can be used in any recording mode other than Premium Auto Pro.
However, note that AF-CS shooting is not supported.
Configure CS Speed, Maximum CS Shots, and Pre-record CS Shots settings on the camera before establishing a wireless LAN connection.
- EX-TR15, EX-TR17, EX-TR35, EX-TR37,
EX-TR50, or EX-TR52: CS shooting is not supported.
• In the case of Prerecord CS, tapping the "PAST" button at the bottom of the smartphones screen will start continual pre-recording of images to a temporary buffer. After that, tapping the shutter button will record the number of images specified by "Maximum CS Shots" (pre-recorded images plus real-time recorded images).
• With some smartphones, you may not be able to send images from the camera if images were recorded with Remote Capture without use of position information enabled.
• You can specify the size of the image sent to the smartphone using "Resize before send".
| |
| 3M |
Images are converted to 3M size before being sent.
• If an original image is 3M size or smaller, it is sent without resizing.
• If an original image size is 3:2 or 16:9, its aspect ratio becomes 4:3. |
| Original (Off) |
Images are sent in the pixels size they were originally recorded. |
|
EXILIM Remote supports the remote capture operations listed below.
• Configuring the self-timer for snapshot shooting
- EX-TR15, EX-TR17, EX-TR35, EX-TR37, EX-TR50, or EX-TR52: The self-timer time is fixed at 10 seconds.
• You can change the flash setting when shooting snapshots. The flash setting cannot be configured for movie and CS image shooting. The flash unit pops up automatically, so make sure your hand is not pressing down on it.
Also, take care there is no pressure applied to flash unit while it is popped up.
- EX-TR15, EX-TR17, EX-TR35, EX-TR37, EX-TR50, or EX-TR52: Flash shooting is not supported. The LED light on/off setting can be configured for shooting.
• Checking the shooting range
• Changing the zoom factor
• Shooting with High Speed CS or Prerecord CS. However, note that AF-CS shooting is not supported.
- EX-TR15, EX-TR17, EX-TR35, EX-TR37, EX-TR50, or EX-TR52: CS shooting is not supported.
• Switching between snapshot and movie shooting
• Sending a snapshot that was just recorded to a smartphone. Movies and CS images cannot be sent.
IMPORTANT!
• Auto Power Off is disabled while a Remote Capture operation is in progress.
Take care to make sure the battery is sufficiently charged.
• Though the camera's monitor screen will go blank a short while after you start a Remote Capture operation, the Remote Capture operation continues.
• Note that the LED flash operation for the Self-time countdown operation cannot be disabled.
• Simultaneous Remote Capture with the same camera by multiple smartphones is not supported.
• Simultaneous Remote Capture with multiple cameras operated by the same smartphone is not supported.
